An ex vivo comparison of bond strength measured by the push-outtest between AH Plus and Endosequence BC sealer Hiflow
DOI:
https://doi.org/10.54589/aol.38/3/210Keywords:
Dentine, Push-Out Bond StrengthAbstract
Endodontic obturation is fundamental to treatment success, with the bond strength of sealer cements to dentin being a crucial parameter for evaluating their effectiveness. Aim: To evaluate the bond strength between root canal dentin walls and the obturation materials AH Plus and Endosequence BC Sealer HiFlow using the push-out test. Material and Method: Twenty single-rooted mandibular premolars were divided into two groups (n=10) according to the sealer used: Group AH (AH Plus Sealer) and Group HF (Endosequence BC Sealer HiFlow). The canals were instrumented with Wave One Gold Large, using 20 mL of 2.5% sodium hypochlorite as irrigation solution. The teeth were cut into 1 mm thick slices in the cervical and middle third regions to perform the push-out test. The failure mode was observed under a stereomicroscope at 40x magnification. The results were subjected to Tukey’s test and ANOVA with a 5% significance level. Results: In the push-out bond strength test, there was no statistically significant difference between AH Plus and Endosequence BC Sealer HiFlow cements (p=0.1952). Similarly, the failure modes showed no significant difference between the cements, in both the cervical and middle thirds (p=0.5703). Conclusion: AH Plus and Endosequence BC Sealer HiFlow demonstrated similar behavior in terms of bond strength and failure mode in root canal dentin walls.
Downloads
Downloads
Published
Issue
Section
License
Copyright (c) 2026 Acta Odontológica Latinoamericana

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
This work is licensed under CC BY-NC 4.0

